Table of Contents
Advertisement
Final Installation
After testing the components, place them in their proper place in the
component and software cabinet. Be sure all unwanted materials have been
removed from the cabinet interior and that the fan and all other components
have been plugged in.
Optional — Adjust PICTURE TILT Switches
If the picture appears tilted, adjust the PICTURE TILT switches on the back of
the TV. These switches compensate for the effect the Earth's magnetic field has
on the picture. The location and position of the TV changes this effect, so try to
adjust the switches with the TV facing the right direction, and located as close
as possible to its installation point.
1. Make sure the STRENGTH switch is in the OFF position. Then move the
STRENGTH switch to the LOW position.
2. If the tilt is still not satisfactory, move the STRENGTH switch to the HIGH
position. If this makes the tilt worse, go to the next step.
3. If the tilt is still not satisfactory, change the position of the the POLARITY
switch, and adjust the STRENGTH switch for the best picture.
Install TV in TV Cabinet
1. Carefully lift TV into position in the TV Cabinet. The front of the TV should
sit back from the front of the TV cabinet.
Clean the TV Screen and TV Trim Frame's Acrylic Shield
1. Make sure TV is turned off.
2. Use a damp soft cloth to clean TV screen and TV trim frame's acrylic shield.
Install Trim Frame
1. Insert trim frame around component and software cabinet — the frames
should not need adjustment.
2. Insert trim frame on TV cabinet.
3. If the front speaker trim frames/grills are not installed, insert them by
aligning the interlocking material.
4. Insert center speaker trim frame by aligning the interlocking material.
25
Advertisement
Table of Contents
