Table of Contents
Advertisement
Final Installation
(continued)
Install Glass Doors
3. Slide doors into hinges with the metal mounting plates toward the inside,
facing the screw holes in the hinge. Secure door into each hinge by inserting the
supplied 1/4" hinge screws into the hinge and gently tightening them against
the metal mounting plate.
Note: The glass door which has RCA Custom Home Theatre on it goes on the left
hand side of the cabinet.
Glass
Door
4. Check each door for proper alignment and adjust, if necessary, by loosening
the screws and moving glass door in or out on the hinge.
5. Pull the foam pads out from inside of each of the push plates. Remove the
paper backing from each foam pad and attach it over the top of each door as
shown below making sure it is located in front of the magnetic latch.
Foam
Pad
6. Repeat the procedures for the remaining doors.
If you have any questions or are missing any
components, please contact 1-800-721-4007
(continued)
Inside of Door Shown
Push
Plate
Glass
Door
27
Advertisement
Table of Contents
