Table of Contents
Advertisement
Install Component and Software Cabinet
The audio/video component and software cabinet is shipped assembled with four
positioning brackets facing inward, and a heat dissipation fan and jack panel extension
cable already installed. The cabinet goes in the bottom of the system opening and sits
on top of the support frame.
Mount Audio/Video Component and Software Cabinet
1. Run the fan's power cord from the outside of the audio/video component
cabinet through the round power cord hole. Later the fan's power cord will
be plugged into the audio/video receiver.
2. Remove the four positioning brackets on the front of the cabinet, reverse their
position, and retighten.
Positioning
Brackets
3. Place the cabinet on top of support frame and slide backward as far as the
positioning brackets will allow. Leave the brackets in place. They will be
removed later.
I
mportant Notes Before Proceeding:
Make sure speaker wires are soldered to terminals on back of jack panel extension
cable. See page 3 for details.
Make sure the leveling legs in the bottom of the audio/video component rack are
positioned on top of the kneewall construction. See the blueprint for kneewall details.
4. Center the cabinet in the opening leaving a 3/16" gap on each side. Use
wood shims, if necessary, so the trim frame can be placed later.
5. Place the outlet strip that came in the accessory kit in the bottom of the
cabinet. Run the strip's power cord through the hole in the back of the
rack and plug it into the wall outlet.
6. Tape the front speaker wires to the top left and right of the audio/video
component and software rack area and the center speaker wire to the
framing lumber in the arch of the opening so they are easily accessible
after the TV cabinet has been installed.
7. Run the AM and FM antenna wires from the outside of the audio/video
component cabinet through the fan's power cord hole in the back of the
cabinet.
Power Cord Hole
Leveling Legs
Positioning
Brackets
5
Advertisement
Table of Contents
