Set Up Channels On Tv For Vcr And Laserdisc Player - RCA HT35752BD Installation & Hook-Up Manual

Test the System
22
(continued)

Set Up Channels on TV for VCR and LaserDisc Player

The TV can be programmed to automatically tune to channel 91 for viewing
pictures from the VCR when you press VCR1 on the remote. When
programmed, press VCR1 on the remote to turn on the audio/video receiver,
VCR, TV, and tune the TV to channel 91.
When programmed, press VCR2/LD on the remote to turn on the
audio/video receiver, LaserDisc player, TV, and tune the TV to 92 to view
the picture from the LaserDisc player.
1. Press TV on the remote to turn on the TV and audio/video receiver. Press
CHANNEL/PRESET to select an active channel. Press VOLUME up or
down to adjust the volume.
2. Press TV MENU on the remote until Setup Menu is highlighted. Press + or
- on the remote to display the setup functions, and then press TV MENU to
select VCR1 Chan function.
Mute
Video Menu
Audio Menu
Setup Menu
3. Enter channel number 91 by pressing 9, then 1 — this is the channel to
which the TV will tune automatically when VCR1 is pressed on the
remote.
4. Press + to enter channel 91 for VCR1 Chan.
5. Repeat Steps 3 and 4, substituting VCR2 Chan and pressing 9, then 2 for
channel 92 to program the TV for the LaserDisc player.
10:23
Chan Ctrl: Normal
Autoprogram
Chan Mem: Stored
Cable/Air: Cable
VCR1 Chan: Off
10:23 INPUT 1 91
CHAN Ctrl: Normal
Autoprogram
Chan Mem: Stored
Cable/Air: Cable
VCR1 Chan: 91
10:23 INPUT 2 92
Autoprogram
Chan Mem: Stored
Cable/Air: Cable
VCR1 Chan: 91
VCR2 Chan: 92
13