Table of Contents
Advertisement
Install Component and Software Cabinet Shelves
Install Glass Shelves
1. After determining the proper shelf position, insert the retainer clips
with screw heads facing down in the correct predrilled holes of the
component and software cabinet as shown below. There are four clips
for each shelf. Do not use less than four since this could damage the
shelf.
2. Slide the glass shelves into the retainer clips so that the front edge of
the shelf is slightly recessed from the front edge of the component
and software cabinet divider. It may be necessary to loosen screws
before inserting the shelf.
3. Tighten the retainer clip screws sufficiently to hold shelves in place.
Do not overtighten.
Note: Store any extra shelves in the bottom of the audio/video cabinet.
Shelf Retainer
Clip
Glass Shelf
Shelf Retainer Clip
(continued)
11
Advertisement
Table of Contents
