Test The Vcr - RCA HT35752BD Installation & Hook-Up Manual

Test the System
(continued)

Test the VCR

See the VCR user's guide for complete VCR operating information.
1. Press VCR1 to turn on the VCR, audio/video receiver, TV, and tune the TV to
channel 91. This will also set the remote to operate the VCR.
2. Press PG•MEM on the remote to display the VCR MAIN MENU. Then press 4
to select the CHANNEL SETUP menu.
VCR MAIN MENU
1 VCR Plus+ Programming
2 Timer Programming
3 Review Programs
4 Channel Setup
1 Auto Search Channels
2 Add/Remove Channels
3 Tuning Mode: CABLE
3. Press 1 to select Auto Search Channels and start the VCR autoprogramming.
The VCR will scan through all channels and place active channels into
memory. The TV will return to a picture when programming is completed.
Press CHANNEL/PRESET up or down to view active channels.
The VCR will automatically select ANTENNA or CABLE during Auto Search
Channels. If you need to manually select antenna or cable TV, press 3 to
switch between ANTENNA or CABLE.
4. Make sure the TV's picture and sound quality are good. Also, check to see
that the TV's picture is from the channel selected on the VCR.
5. Insert a cassette in the VCR, and press PLAY to check playback capability.
If the safety tab has been removed from the cassette, it will begin playback
automatically.
CHANNEL SETUP
CH 14
Searching Channels
23