Table of Contents
Advertisement
Final Installation
26
(continued)
Install Glass Doors on Component and Software Cabinet
The final installation step is assembling and installing the glass doors on the
component and software cabinet. When installed, the two outer doors will open
outward and the two inner doors will open toward the center. Hinges and
magnetic catches have been preinstalled for the four supplied doors.
1. Position the left pair of glass doors in front of cabinet and determine the
position of the push plates and the four metal mounting plates.
2. Peel the paper from the metal mounting plates and stick them to the inside of
the glass doors flush with the top and bottom of the door and approximately
1/16" from the side as shown below.
Metal
Mounting
Plate
Glass
Door
Inside of Glass Door
(continued on next page)
Advertisement
Table of Contents
