2. Major Mechanical Parts Replacement &
Adjustment Procedures
GENERAL
When mechanical parts are replaced, pay attention to
the following notes.
1. Always turn power off before replacing any parts.
2. If any adjustment is required after replacing parts,
perform the required adjustment.
3. Use proper tools and fixtures.
4. Be sure to clean the parts after replacement, and
also to replace the mechanical parts, follow the
replacement procedure.
2-1. Cylinder Unit Replacement
(Removal)
1. Remove the T1 Guide and Cleaning Arm Unit.
(Please refer to item "2-2. Cleaning Arm Unit
Replacement")
2. Unscrew the screw (B) which fix the cable (B) as
shown in Figure 2-1-2.
3. Remove the flexible cable which connected to
connector (A) on the P.C.Board (A) as shown in
1-1-1.
Click this button
, then go to item "7. Table of
Connector".
4. Unscrew the 3 screws which have spring from the
Cylinder Unit as shown as Figure 2-1-1, then
remove the Cylinder Unit without touching any
mechanical parts as shown in Figure 2-1-2
Figure 2-1-1
NOTE:
Don't touch the cylinder by finger directly, when
pull out the Cylinder Unit.
(Installation)
1.
Install the new Cylinder Unit according to the
opposite procedures of removing.
NOTE:
When installing the Cylinder Unit, the pin on Mech.
Chassis should match with holes of Cylinder Unit as
shown in Figure 2-1-3.
2. After installing the T1 Guide, T1 Guide Position
Adjustment should be performed.
(Please refer to item "2-2. Cleaning Arm Unit
Replacement" and "2-3. T1 Guide Position
Adjustment")
MECH-34
Figure 2-1-2
Figure 2-1-3