Siemens SIMATIC ET 200SP Manual page 15

Properties
The module has the following technical properties:
● Measurement of electrical variables from single-phase and three-phase supply networks
● Max. nominal voltage between two outer conductors 400 VAC
● Recording of:
– Voltages
– Currents
– Phase angles
– Power
– Energy / electrical work
– Frequencies
– Power factors
The module supports the following functions:
Table 2- 1 Version dependencies of the functions
Function
Firmware update
Identification data I&M0
to I&M3
Reconfiguration in RUN
Diagnostic error inter-
rupts
Accessories
The following accessories must be ordered separately:
● BaseUnit Type D0
● Labeling strips
● Reference identification label
You can find additional information on the accessories in the ET 200SP distributed I/O
system (http://support.automation.siemens.com/WW/view/es/58649293) system manual.
Analog input module AI Energy Meter 400VAC ST (6ES7134-6PA01-0BD0)
Manual, 10/2017, A5E36061895-AB
HW ver- FW version
sion
FS01 V3.0.0 or
higher
FS01 V3.0.0 or
higher
FS01 V3.0.0 or
higher
FS01 V3.0.0 or
higher
2.2 Properties of the AI Energy Meter 400VAC ST
STEP 7
TIA Portal
V13 SP1 with V5.5 SP4 and
update 4 and HSP hotfix 7 or
or higher higher
V13 SP1 with V5.5 SP4 and
update 4 and HSP hotfix 7 or
or higher higher
V13 SP1 with V5.5 SP4 and
update 4 and HSP hotfix 7 or
or higher higher
V13 SP1 with V5.5 SP4 and
update 4 and HSP hotfix 7 or
or higher higher
GSD file
V5.x PROFINET IO
X
X
X
X
Product overview
PROFIBUS DP
---
X
X
X
15