Lenovo BladeCenter HX5 7873 Problem Determination And Service Manual page 203

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See "Parts listing - BladeCenter HX5" on page 57 to determine which components are CRUs and which
components are FRUs.
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Type Error Message
Information Group 4, processor (CPU Fault
Reboot) OEM system boot event
Error Code: 0x806F0113
Error Chassis (NMI State) bus timeout
Error Code: 0x806F011B
Note: Multiple events can be displayed for this error code. Be sure to read the message text to determine the
appropriate recovery actions.
Error
System board, interconnect (Scale-
Flex cable) configuration error
Error Blade bezel 1, interconnect (Front
panel) configuration error
Action
Information only; no action is required.
1. Remove the blade server from the BladeCenter chassis;
then, reinstall it.
2. Reseat all the optional devices installed in the blade server
one device at a time, restarting the blade server each time,
to determine where the problem is located.
3. Remove optional devices from the blade server one at a
time to determine where the problem is located.
4. Replace the following components one at a time, in the
order shown, restarting the blade server each time:
a. All optional devices installed in the blade server
b. (Trained service technician only) Replace the system-
board assembly (see "Removing the system-board
assembly - BladeCenter HX5" on page 140 and
"Installing the system-board assembly - BladeCenter
HX5" on page 142).
1. Reseat the scalable blade complex (see "Removing the
blade server from the BladeCenter chassis" on page 66
and "Installing a blade server in a BladeCenter chassis" on
page 67).
2. Reseat the scalability expansion card (see "Removing the
2-node scalability card" on page 83 and "Installing the 2-
node Scalability card" on page 85).
3. (Trained service technician only) Replace the system-
board assembly (see "Removing the system-board
assembly - BladeCenter HX5" on page 140 and "Installing
the system-board assembly - BladeCenter HX5" on page
142).
1. Reseat the operator control panel (see "Removing the
control panel" on page 124 and "Installing the control
panel" on page 126).
2. Replace the operator control panel (see "Removing the
control panel" on page 124 and "Installing the control
panel" on page 126).
. 187
Chapter 5 Diagnostics