Setting The Transmission Conditions - Toshiba E-STUDIO45 Operator's Manual

4. SETTING THE TRANSMISSION CONDITIONS

You can send originals under different transmission conditions (resolution, image quality mode, expo-
sure, transmission mode, original size, ECM, quality TX and line).
If you change the transmission conditions, the new settings are valid for one transmission only.
The following describes the settings of each item.
• Resolution :Set the resolution when you scan the original to be sent.
STANDARD, FINE, U-FINE
* If the remote FAX cannot receive originals at the same resolution, the resolution of the sent
original is automatically converted before it is sent. The finer the resolution, the longer it takes
to send an original.
• Image Quality Mode : Set the image quality mode when you scan the original to be sent.
TEXT, PHOTO/TEXT, TEXT
* Transmission time may be longer than usual in case the PHOTO/TEXT mode or PHOTO mode
is selected.
• Exposure : Set the image density according to the contrast of the original to be sent.
AUTO, MANUAL (changeable in 11 steps)
* In the automatic exposure mode, the digital copier automatically judges the contrast of the
original, and selects the ideal contrast.
In the manual exposure mode, you can adjust the contrast manually in 11 steps.
• Transmission mode : Set the transmission mode by which the original is to be sent.
MEMORY TX, DIRECT TX
• Original Size : Set the scanning size of the original to be sent.
AUTO : The size of the placed original is automatically judged before it is scanned.
SPECIFIED SIZE : The original is scanned at the preset size regardless of its actual size.
* When originals are placed in the reversing automatic document feeder, they are scanned in the
AUTO mode. You can specify the size only when the original is placed on the original glass.
• ECM : ECM (=Error Correction Mode) is the communication mode using the automatic error correction
method which has been internationally standardized. Even when the transmitted data have been
influenced by noise during communication, this mode allows good communication without image
disorder by automatically resending the part that has been influenced.
ON, OFF
* Both the transmitter and the receiver must have the ECM function to make ECM communication
available. When influenced by noise, etc. during communication, communication time becomes
longer than usual.
• Quality TX : Set whether or not to specify Quality TX.
ON, OFF
* When this item is set to "ON", originals are sent at a speed lower than normal.
• Line : Specify the line to be used when you send the original (with the 2nd line board attached)
Page 5-20
OFF, LINE1, LINE2
* When you send multi-page originals by placing them on the reversing automatic document feeder, you
cannot change the scanning conditions for each page.
When originals are placed on the original glass, you can change the following scanning conditions for
each page. Page 2-11
• Resolution
• Exposure
* Changing the default settings (HOME POSITION) when sending originals.
Use this mode when you are using non-standard size paper or you want to
limit the area of the original to be sent.
• Image quality mode
• Original size
Page 3-6
Page 5-16
1
2
3
4
5
6
7
8
9
10
11
12
2-9