Wire Routing - Invacare TDXSPBASE Service Manual

Wire Routing

NOTE: For this procedure, refer to FIGURE 10.5 on page 77.
Removing Wiring
1. Remove the rear shroud. Refer to Adjusting the Formula CG Seating System Mounting Position on page 58.
2. If necessary, cut the existing tie-wraps securing wiring to the wheelchair.
3. Disconnect necessary cables from the controller (Detail "A").
Securing Wiring
1. Connect the necessary cables to the controller (Detail "A").
2. Using new tie-wraps, secure the wiring to the wheelchair according to FIGURE 10.5.
3. Install the rear shroud. Refer to Adjusting the Formula CG Seating System Mounting Position on page 58.
Connect Joystick
Cable Here
Connect Left Side Motor Cable Here
Secure Left Side
Motor Cable Here
Bundle Joystick, Motor and Battery
Cables and Secure Here
Part No 1143209
Connect Battery Cable Here
Secure Joystick Cable Here
FIGURE 10.5 Wire Routing
77
SECTION 10—ELECTRONICS
DETAIL "A"
Connect Right Side Motor Cable Here
NOTE: The joystick cable will be secured
along with the motor cable according to
which side of the wheelchair the joystick is
mounted to.
Secure Right Side
Motor Cable Here
TDX® SP