Genie GS-2668RT Operator's Manual page 35

Fifth Edition · Second Printing
Driving on a slope
Determine the slope and side slope ratings for the
machine and determine the slope grade.
GS-2668 RT
Maximum slope rating,
stowed position
Maximum side slope rating,
stowed position
GS-3268 RT
Maximum slope rating,
stowed position
Maximum side slope rating,
stowed position
Note: Slope rating is subject to ground conditions
and adequate traction.
To determine the slope grade:
Measure the slope with a digital inclinometer OR
use the following procedure.
You will need:
carpenter's level
straight piece of wood, at least 3 feet / 1 m long
tape measure
Part No. 133534
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top edge of
the piece of wood and lift the end until the piece of
wood is level.
While holding the piece of wood level, measure the
distance from the bottom of the piece of wood to
40% (22°) the ground.
Divide the tape measure distance (rise) by the
40% (22°)
length of the piece of wood (run) and multiply by
100.
Example:
35% (19°)
35% (19°)
rise
Run = 12 ft (144 in) / 3.6 m
Rise = 12 in/ 0.3 m
12 in ÷ 144 in = 0.083 x 100 = 8.3%
0.3 m ÷ 3.6 m = 0.083 x 100 = 8.3%
If the slope exceeds the maximum slope or side
slope rating, then the machine must be winched or
transported up or down the slope. See Transport
and Lifting section.
GS-2668 RT • GS-3268 RT
Operator's Manual
Operating Instructions
run
33