Genie GS-2668RT Operator's Manual page 28

Operator's Manual
Inspections
Test Limited Drive Speed
26 Push and hold the lift function enable button.
Raise the platform approximately 1.8 m from the
ground.
27 Press and hold the function enable switch on the
control handle.
28 Slowly move the control handle to the full drive
position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
22 cm/s.
If the drive speed with the platform raised exceeds
22 cm/s, immediately tag and remove the machine
from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
29 Fully lower the platform.
30 Drive both wheels on one side onto a 10 cm
block or onto a curb.
31 Raise the platform at least 1.8 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
indicator light on the lift function enable button
will be red.
32 Move the drive control handle in the direction
indicated by the blue arrow, then move the drive
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
33 Lower the platform and drive the machine off the
block.
26
Test the Emergency Lowering
34 Push and hold the lift function enable button and
raise the platform approximately 60 cm.
35 Push in the red Emergency Stop button to shut
off the engine.
36 Pull out the red Emergency Stop button to the
on position.
37 Push and hold the lift function enable button.
Activate the up/down rocker switch in the
direction indicated by the yellow arrow.
Result: The platform should lower.
GS-2668 RT • GS-3268 RT
Fifth Edition · Second Printing
Part No. 133534