SECTION 4 – NAV/COM &
TRANSPONDER
4.6
FREQUENCY AUTO-TUNING
Auto-tuning on the PFD
Figure 4-9 Nearest Airports Window (PFD)
Press the NRST Softkey to display the Nearest
1)
Airports Window.
Turn either FMS Knob to highlight the desired
2)
frequency.
Press the ENT Key to place the frequency in the
3)
standby field of the active COM.
Press the Frequency Transfer Key to place the
4)
frequency in the active field.
NAV frequencies are entered automatically in the NAV
window upon approach loading or approach activation.
Auto-tuning on the MFD
Auto-tuning on the MFD is done in much the same way
as on the PFD. Use the FMS Knobs to select the desired
frequency on any of the information pages. Pressing the
ENT Key then loads the selected frequency in the tuning
box as a standby frequency.
4-4
Garmin G1000 Cockpit Reference Guide for the Beechcraft A36/G36
4.7
TRANSPONDER
Mode Selection
The STBY, ON and ALT Softkeys can be accessed by
pressing the XPDR Softkey.
Ground Mode (Automatic)
GND is displayed when the aircraft is on the ground.
Figure 4-10 Ground Mode
Reply Status
When the transponder sends replies to interrogations,
an "R" indication appears momentarily in the reply status
field.
Figure 4-11 Reply Indication
Code Selection
Press the XPDR Softkey to display the
1)
transponder Mode Selection softkeys.
2)
Press the CODE Softkey to display the
transponder Code Selection softkeys, which
includes the digit softkeys.
3)
Press the appropriate digit softkeys to enter
the code in the four-digit code field of the
Transponder Status bar. Five seconds after the
fourth digit has been entered, the transponder
code becomes activated.
When entering a code, press the BKSP Softkey
as needed to back up and change code
digits.