Table of Contents
Advertisement
Commissioning
7.5 5 minute quick start with the operator panel and the Ready-for-Use software
7.5.2
Standard parameter settings
The quick setup is based on the standard parameter settings. The previously set parameters
must therefore be reset prior to the quick setup (except the Ethernet address and Modbus
parameters). Service mode must be switched on first. Resetting to the standard parameters
can then be carried out.
Figure 7-2
46
Quick start step 2
SIWAREX WP231
Manual, 07/2014, A5E31238908A-02
Advertisement
Table of Contents
