Xsp Dispenser Preparation - Jackson ECOLAB ES-2000 Installation & Operation Manual

Es series door type, chemical sanitizing, single and dual rack dishmachines

Table of Contents

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

Machines that are equipped with the XSP package have a unique feature over other Ecolab models such as the ES-2000 or

ES-4000: the XSP machines use solid, rather than liquid detergent and rinse aid products (all machines use liquid sanitizing

agents). The solid product dispensing system is self-contained on top of all XSP units.

Operation of any dishmachine with the XSP dispenser is covered under the operational instructions found in this manual. The

solid detergent is automatically dispensed during the wash cycle. The machine will then dump the wash water, flush the tank,

and then should refill the tank with fresh water during the rinse cycle. The sanitizer and solid rinse aid are automatically dis-

pensed during the rinse cycle.

Optimum dispensing control of the solid products has been achieved with this solid dispensing system. The detergent reservoir

has an indexing pedestal that keeps the product at a constant distance from the nozzle. The detergent pedestal is the major

reason why dispensing is very consistent from cycle to cycle. Another important feature which adds to the consistency of the

dispensing is the pressure regulators. Two dispenser pressure regulators are an integral part of the system. By closely regu-

lating the feed water pressure to the products, uniform dispensing rates are achieved.

The solid detergent is available in 2 x 9 lb cases. the solid rinse aid is available in 3 x 0.75 lb cases. Both products have been

custom formulated for the unique operating characteristics of the XSP machine and dispensing system.

Dishmachines equipped with the XSP dispenser will have an overall height approximately 4-1/4" above the height of the con-

trol box, which is normally 66-1/4". Machine width and table height are unaffected by the addition of the system.

The operating parameters and capacities of machines equipped with an XSP dispenser are not affected by the addition of the

system.

There are no special instructions for installing a unit equipped with an XSP dispenser.

NOTE: DETERGENT SAFETY SWITCH MUST BE DEPRESSED FOR THE DISHMACHINE TO RUN!! (Refer to

Figure 1 below)

1. Remove the screw cap on the detergent capsule.

2. Invert the capsule holding on to the molded handle and place the detergent onto the pedestal.

3. Remove the snap lid on the rinse additive container and let the product fall onto the stainless steel screen in the Rinse

Additive Cylinder.

RINSE

ADDITIVE

CYLINDER

STAINLESS

STEEL SCREEN