Operation; Operating Instructions; Preparation; Power Up - Jackson CONSERVER XL-E Installation, Operation And Service Manual

OPERATION

PREPARATION

POWER UP

FILLING THE
WASH TUB
If water level needs
adjusted, see the
CAM Timer Operation
section and follow the
instructions for CAM 5.
07610-003-92-84-Q

OPERATING INSTRUCTIONS

Before operating the unit, verify the following:
1. The sump strainer and pan strainer are in place and clean.
2. The drain stopper is installed.
3. The wash/rinse arms are installed and secure.
To place the unit in standby, flip the "OFF/ON/FILL" switch to the ON position.
1. For the initial fill (installation or beginning of day), close the door and depress
and hold the "OFF/ON/FILL" switch in the FILL position for approximately 8-10
seconds.
2. Open the door and verify water level is correct. Water must be between the lines
on the drain stopper. For lowest energy use, water should be at the lowest line
on the drain stopper. This is only necessary during the initial fill. After this, the
water level is controlled by the timer.
Operating
Range
Highest
Energy
Usage
Lowest
Energy
Usage
17