Step 1 - Create A New Project; Step 2 - Enter Project Details - Belkin F1DN104K-3 Configuration Manual

Step 1 – Create a new Project
Each KM configuration file is called a "KM Configuration Project". For
every setup you will be required to create a new project.
At any point during the wizard the administrator can click "Back" and
return to the previous stage.

Click on "New Project"
Figure 1 – Launching a new KM Configuration Project
Step 2 – Enter Project Details
Please enter the requested information in the following manner:

Project Name – The name can be a combination of English
characters and numbers. It is advised to use a name that will
reflect the configuration for example: "Dealer 3 5 displays",
"Generic Workstation 7". The project name can be read from
the KM after loading.
9
Section 2 - Configuration

Product Model – The product model can be found on the
back sticker of the KM switch. Each KM port can support up
to 4 connected displays.

Mouse Speed – This is the default mouse cursor speed for all
systems. Note that changes in the mouse speed at each
computer will not affect the resulted KM mouse speed. If
value is unknown – leave 5 (default) and try it.

Mouse Acceleration – Set the mouse cursor acceleration
value (the rate at which cursor speed is increasing). Note that
changes in the mouse acceleration at each computer will not
affect the resulted KM mouse acceleration. If value is
unknown – leave 5 (default) and try it.

Number of Computers – The total numbers of computers
that will be connected to the KM switch for this
configuration.

Click "Next Step" once done entering data.