Wired Programming - Radio Shack PRO-528 User Manual

Beyond the Basics
To turn it off, hold down
until
Note: Using keylock does not prevent
Notes
the scanner from scanning channels.

wired programming

You can transfer programming data to your
scanner using your PC and an optional
interface cable (available at your local
RadioShack store) and software (available
at your local RadioShack or
www.radioshack.com).
Note: If the scanner receives no
data from the PC for more than 20
Notes
seconds, T-Err appears and wired
programming stops.
1. Make sure your scanner is turned off.
2. Connect the interface cable to your
computer and then connect the other
end of the cable to PC/IF on the side of
the scanner.
3. Install the software to your computer
and run the program.
4. To set up the program, click on Tools,
select Confi guration, and select PRO-
528 (if necessary).
5. Turn the scanner on. The scanner
automatically goes into the wired
programming mode. PGM and WirEd
disappears.
36
/KEYLOCK