Transferring Data From A Pc; Wired Programming - Radio Shack 20-135 Quick Start Manual

5. When the data transfer is completed,
appears on both units. If the transfer was not
successful,
6. After the clone operation is complete, remove
the cable, turn both units off and then on again.

Transferring Data From a PC

Wired Programming

You can transfer programming data to your
scanner using your PC and an optional interface
cable and software (available at your local
RadioShack or www.radioshack.com).
1. Make sure your scanner is turned off.
2. Connect the interface cable to your computer
and then connect the other end of the cable
to the scanner's PC/IF jack.
3. Install the software to your computer and run
the program.
4. To set up the program, click on Tools, select
Configuration, and select PRO-135 (if
necessary).
5. Turn the scanner on. The scanner auto-
matically goes into the wired programming
WirEd
mode.
scanner begins to communicate with the PC,
PC
flashes.
PC
6. stops flashing when the scanner has
successfully received all data. Turn the
scanner off and remove the cable.
7. Turn the scanner on again.
Advanced Programming
Error
appears.
PGM
and
31
appear. When the
donE