Wired Programming - Radio Shack PRO-83 User Manual

Wired Programming

You can transfer programming data to your scanner
using your PC and an optional interface cable (Cat.
No. 20-289, available at your local RadioShack store)
and software (available at your local RadioShack or
www.radioshack.com).
Note: If the scanner receives no data from the PC
for more than 20 seconds, T-Err appears and wired
programming stops.
Make sure your scanner is turned off.
Connect the interface cable to your computer
then connect the other end of the cable to PC/IF
on the side of the scanner.
Install the software to your computer and run the
program.
Beyond the Basics 52