Wired Programming - Radio Shack PRO-2051 User Manual

Beyond the Basics
1. Select the trunking programming mode and the bank you
want to change.
2. Press or to select Motorola Type 2 or Motorola Type
e d
1, then press E.
3. Press or to select Eot, then press E.
e d
4. Press or to select Eot ON or Eot OFF, then press E.
e d
If you set the squelch so you hear a hissing sound, the
Note Note
scanner will remain on the voice channel, even when a
disconnect tone is transmitted or there is no signal at all.

wired programming

You can transfer programming data to your scanner using
your PC and an optional interface cable and software (available
at your local RadioShack store or www.radioshack.com).
If the scanner receives no data from the PC for more than
Note Note
20 seconds, T-Err appears and wired programming stops.
1. Make sure your scanner is turned off.
2. Connect the interface cable to your computer. Then
connect the other end of the cable to PC/IF at the rear of
the scanner.
3. Install the software to your computer and run the
program.
4. To set up the program, click on Tools, select
Confi guration, and select PRO-2051 (if necessary).
5. Turn on the scanner. The scanner automatically goes into
the wired programming mode. PGM and WirEd appear.
Then send the data from the PC. Data frame numbers
being received appear.
75