Grizzly G0796 Owner's Manual page 63

G0797
Tools Needed
Screwdriver Phillips #2 ...................................... 1
Hex Wrench 5mm .............................................. 1
Wrench 17mm.................................................... 1
External Retaining Ring Pliers .......................... 1
To replace belts or brake shoes:
To replace belts or brake shoes (G0797):
1.
DISCONNECT MACHINE FROM POWER!
2. Remove drawbar (see Page 41).
3. Remove (4) motor mount cap screws, then
remove motor (see Figure 93).
4. Remove headstock
Figure 93) and drive belt.
Motor Mount
Cap Screws
(3 of 4)
Headstock
Side Cover
Figure 93. Location of G0797 motor mount cap
screws and headstock side cover.
— If replacing drive belt, install new belt using
headstock side cover opening for access
to guide new belt onto motor pulley as you
position motor for re-installation, then re-
install motor with new belt installed.
— If replacing timing belt or brake shoes,
proceed to Step 5.
Model G0796/G0797 (Mfd. Since 1/18)
Qty
side cover (see
5. Remove (3) cap screws from spindle bearing
cover (see Figure 94).
Cap Screws
Bearing
Cover
Figure 94. Spindle bearing cover located on top
of headstock.
6. Pry off spindle bearing cover (see Figure 95).
Screwdrivers
Figure 95. Using two flat head screwdrivers to
remove spindle bearing cover.
-61-