Table of Contents
Advertisement
Power Feed Test Run
This mill comes with a power feed unit for X-axis
table travel. Proper operation of the limit switch
attached to the front middle of the table is
important to the operation of this power feed unit.
If the power feed does not operate as expected
during the following steps, disconnect it from
power and contact our Tech Support at (570) 546-
9663 for assistance.
During power feed operation, ball handles
spin rapidly when engaged. Always stay
clear of ball handles when using power
feed. Failure to do so could lead to entan-
glement or impact injuries.
To test run power feed:
1.
Make sure all tools, cables, and other items
are well clear of table movement and potential
direction of travel.
2.
Refer to Operating X-Axis Power Feed
section, beginning on Page 31, to understand
how power feed, table locks, and limit switch
function.
3.
Loosen table locks on front of table.
4.
Plug power feed power cord into a grounded
110V power outlet.
Model G0796/G0797 (Mfd. Since 1/18)
5.
Make sure power feed direction knob is in
neutral (middle) position, turn speed dial
counterclockwise to lowest setting, then
press ON button.
6.
Turn direction knob to left, slowly turn speed
dial clockwise to increase speed, then con-
firm that table is moving to left.
7.
Watch for table limit stop to hit limit switch
and turn power feed OFF, stopping table
movement.
8.
Turn direction knob through neutral (middle)
position and all the way to the right. Table
should begin moving to the right.
9.
Confirm that table stops moving when limit
stop presses against limit switch plunger.
10. Move direction knob to neutral (middle) posi-
tion, turn speed dial to lowest setting, and
press OFF button.
Congratulations! The Test Run of the mill is
complete. Continue to the next page to per-
form the Spindle Break-In and Inspections &
Adjustments procedures.
-27-
Advertisement
Table of Contents
