Table of Contents
Advertisement
Table Limit Stops
Two adjustable table limit stops are located at
each end of the table (see Figure 25). They limit
automatic table movement by pressing the table
limit switch, which stops the X-axis power feed
unit.
To adjust the position of the limit stops, loosen
the cap screws securing the stops, reposition, and
tighten securely. If not being used, position stops
at far ends of table so as not to interfere with table
movement.
Operating X-Axis Power Feed
Tool Needed
Hex Wrench 8mm .............................................. 1
To operate X-axis power feed:
1.
Loosen X-axis locks.
2.
Turn speed dial (see Figure 25) all the way
counterclockwise to slowest setting.
3.
Move direction knob to neutral (middle)
position, press feed/jog switch to left (feed
position), then push ON/OFF button (see
Figure 25).
Limit
Switch
Limit Stop
Speed
Dial
Direction
Knob
ON/OFF
Button
Figure 25. Location of X-axis power feed
controls.
Model G0796/G0797 (Mfd. Since 1/18)
Qty
(1 of 2)
Feed/Jog
Switch
Rapid
Traverse
Button
4.
With your hand poised over ON/OFF button
in case you need to suddenly turn unit OFF,
move direction knob to select desired direc-
tion of table travel.
5.
Use speed dial to slowly bring speed of
movement up to desired rate.
To jog table, move Feed/Jog switch (see
Figure 25) to right (Jog) position. Table will
move in selected direction until switch is
released.
To cause table to instantly move at full speed
when already in motion, press the rapid
traverse button (see Figure 25). The table
will resume previous speed when button is
released.
6.
When you are finished using power feed:
a. Turn unit OFF.
b. Rotate speed dial all the way counter-
clockwise.
c. Move direction knob to neutral (middle)
position to avoid unexpected table move-
ment later.
For additional component details, refer to X-Axis
Power Feed Identification on Page 8.
-31-
Advertisement
Table of Contents
