Table of Contents
Advertisement
7.
Remove (3) hex nuts with washers that
secure upper housing to quill housing (see
Figure 89).
Note: The upper housing is composed of the
gear housing and the belt housing, which you
will separate in Step 9.
Upper
Housing
Hex Nuts
w/Washers
(2 of 3)
Figure 89. Location of hex nuts and washers
that secure upper housing to quill housing.
8.
With upper housing removed (see Figure
90), you can now separate gear housing from
belt housing.
Figure 90. Belt housing placed upside down on
workbench.
-60-
9.
Use a 5mm hex wrench to remove gear
housing from belt housing (see Figure 91).
Belt Housing
Quill
Housing
Figure 91. Once gear housing is separated from
belt housing, both belts can be accessed.
10. Inspect both belts for damage or wear.
Replace if necessary.
11. Slide motor pulley up to remove it from
belt housing (see Figure 92), inspect brake
shoes for damage or wear, and replace if
necessary.
Motor Pulley
Figure 92. Removing motor pulley to gain
12. Re-assemble machine in reverse order from
Steps 2–11.
V-Belt
Gear Housing
Timing Belt
Brake Shoes
access to brake shoes.
Model G0796/G0797 (Mfd. Since 1/18)
Advertisement
Table of Contents
