Grizzly G0796 Owner's Manual page 58

5. Loosen two cap screws on face of leadscrew
nut shown in Figure 81.
Y-Axis Leadscrew Nut
& Cap Screws
Figure 81. Y-axis leadscrew nut and cap screws.
-56-
6. Re-install key back onto leadscrew so that
you can use ball handle in next step.
7. Rotate adjustment plate on leadscrew nut
in small increments, slide ball handle onto
leadscrew, then check amount of backlash.
8.
When you are satisfied with adjustment, re-
tighten two cap screws.
9.
Re-install parts previously removed in reverse
order.
Model G0796/G0797 (Mfd. Since 1/18)