Steam Delivery - Fisher & Paykel EB60 User Manual

IMPORTANT!
Do not leave the appliance unattended while steam is being delivered.
●
Always stop steam delivery before extracting the container filled with liquid
●
to avoid burns from splashes.
1
Make sure the steam wand is attached correctly to the hot water/steam connection nozzle.
2
Fill a container with water to be heated or milk to be frothed and immerse the spout
in the liquid.
3
Select STEAM from the display. After a few seconds, steam to heat the liquid is
delivered from the steam wand.
4
When the desired temperature or level of froth is reached, end steam delivery by
pressing CANCEL.
Note: If 'Energy saving' is enabled, you may have to wait a few seconds before steam
is delivered.
Tips for using steam to froth milk
When choosing the size of the container, bear in mind that the liquid doubles or
●
triples in volume.
For a richer denser froth, use skim or light milk at refrigerator temperature (about 5°C).
●
For a creamier froth, rotate the container with slow movements in an upward direction.
●
To avoid milk with poor froth or large bubbles, always clean the spout as described
●
in the following section.
Cleaning the steam wand and after use
Always clean the steam wand after use to avoid the build-up of milk residues and
prevent it from clogging.
1
Place a container under
the steam wand and deliver
a little water (see section
'Delivering hot water').
Stop delivery of hot water
by pressing CANCEL.
5
Check the hole in the connection nozzle is not blocked. If necessary, clean using
a toothpick.
6
Wash all parts of the spout thoroughly with a sponge and warm water.
7
Insert the connection nozzle, then the end of the spout onto the steam wand by
pushing it upwards and turning it clockwise until it is attached.

STEAM DELIVERY

2
Wait a few minutesfor the spout
to cool down, then extract.
3
Hold the spout with one hand
and with the other, turn the
end of the spout and pull it
downwards.
4
Also remove
the steam
connection
nozzle by
pulling it
downwards.
25