Table of Contents
Advertisement
Figure 6-8
NOTICE
Modifying the cable outlet direction
Changing the cable outlet direction by any improper means will damage the connecting
cables.
The permissible rotation range must not be exceeded. A maximum of ten changes to the
rotation angle of the Sensor Module are permissible within the rotation range.
6.3.4
Connect the holding brake
Information for electrically connecting the holding brake can be found in the operating
instructions supplied by the manufacturer in the (Page 169) appendix.
6.3.5
Connecting the temperature sensor
● The temperature sensor is connected to the signal connector together with the speed
● For the version without speed encoder, the temperature sensor is connected at the terminal
● The motor has a reserve temperature sensor, which is also connected at the auxiliary
SIMOTICS M-1PH8 1PH818., 1PH822., 1PH828.
Operating Instructions 10/2017
Sensor Module
encoder signal.
strip.
terminal strip. Reconnect the temperature sensor as needed, e.g. if the previous
temperature sensor fails.
①
mounted on the terminal box
Electrical connection
6.3 Auxiliary circuits
83
Advertisement
Table of Contents
