Table of Contents
Advertisement
Mounting
5.2 Lift the machine to where it will be mounted and position it
Note
Type of balancing
In the case of shaft extensions with feather keys, the type of balancing is also included on the
rating plate next to the CE mark.
5.2.5
Lifting and transporting the machine
To safely lift and transport the machine, the following requirements must be met:
● Personnel operating cranes and fork-lift trucks must be appropriately qualified.
● If the motor is packed, depending on the weight, size and on-site conditions, lift crates and
● When lifting the machine, use only approved and undamaged sling guides and spreaders
● When lifting the machine, refer to the information on the lifting plate.
● Use only the load carrying device on the stator frame for lifting.
Transport for a different type of construction
If you do not transport or lift the machine in a position appropriate for its construction, the
machine can tip, slip into the lifting equipment or fall down. This can result in death, serious
injury or material damage.
● Use only the load carrying device on the stator frame for lifting.
● Use the load carrying device appropriate for the machine position.
● Use suitable rope guiding or spreading devices. The weight of the machine is shown on
56
transport frames using a fork-lift truck or a crane with slings. Use a crane or fork-lift truck
suitable for the load.
of sufficient rated capacity. Check the lifting equipment prior to its use. The weight of the
machine is shown on the rating plate.
– Comply with the specified spreading angles.
– Do not exceed the maximum lifting acceleration and lifting speed specified on the lifting
plate. Lift the machine without jerking it.
Acceleration a ≤ 0.4 g (≈ 4 m/s
Velocity v ≤ 20 m/min
WARNING
the rating plate.
)
2
SIMOTICS M-1PH8 1PH818., 1PH822., 1PH828.
Operating Instructions 10/2017
Advertisement
Table of Contents
