Alcatel-Lucent MDR-8000 User Manual page 89

MODULE/UNIT
AE-27AF Relay Interface
AE-37Y Controller
CE-16BB Power Supply
Fuse
DX-35M DS1/E1 I/O Interface
DX-35N DS3 I/O Interface
(Early Versions)
DX-35P OC3/STM-1
I/O Interface
DX-35R/S ETH I/O Interface
UD-35( ) Transmitter
Crystal Oscillator Subboard
Capacity Key
UD-36( ) Receiver
Crystal Oscillator Subboard
Capacity Key
UD-51( ) Power Amplifier
Hot-Standby Shelf
CommPak Indoor Shelf
LBO/AUX/Line Interface
Hot-Standby Shelf
CommPak Indoor Shelf
RF Switch
(1)
If ATPC is in use, it must be provisioned disabled or locked high before removing controller.
(2)
Applicable to older versions of RCVR with Freq Cont on front panel.
Table 5-6 Module Replacement Matrix
REMOVAL/REPLACEMENT
PROCEDURE
No Special Procedure Required
Para. 5.14
Para. 5.13
No Special Procedure Required.
Refer to Operations Section for
Location.
No special procedure required.
Para. 5.15
Para. 5.16
Para. 5.16
Para. 5.17
Figure 5-15
Figure 5-16
Para. 5.22
Figure 5-22
Figure 5-23
Para. 5.24
Appendix A on enclosed CD
Maintenance Section on
enclosed CD
Appendix H on enclosed CD
Maintenance Section on
enclosed CD
CHECKS/ADJUSTMENTS
PROCEDURE
None Required
None Required
None Required
None Required
Para. 5.15 and Table 5-9
None Required
None Required
Para. 5.18, Para. 5.19,
Para. 5.20, and Para. 5.21
The Crystal Oscillator Sub-
board and crystal part numbers
define this unit. The crystal is sol-
dered to the oscillator subboard
and factory tuned to the custom-
ers requirements.
2
Para. 5.23
The Crystal Oscillator Sub-
board and crystal part numbers
define this unit. The crystal is sol-
dered to the oscillator subboard
and factory tuned to the custom-
ers requirements.
Para. 5.25
No Special Procedure Required
No Special Procedure Required
No Special Procedure Required
5-31