Alcatel-Lucent MDR-8000 User Manual page 49

Channel
TMN
Select channel 1, 2, or 3 as
service channel to be used for MCS
transport and/or PPP transport.
Select OFF to disable MCS and
PPP transport.
For MCS-11 to operate properly, all radio controllers in a system inter- connected by RF
or RPTR must have the same PPP transport provisioning on facing (interconnecting)
interfaces. The valid transport combinations (for terminal or repeater) are shown. The
combination chosen from MCS TRANSPORT and PPP TRANSPORT determines the
RPTR PORT and RF PORT PROTOCOLS supported.
Figure 4-23 MCS/TMN Transport Provisioning (Sheet 1 of 5)
3 MCS Transport
Note
Note
MCS-11 must be enabled even if it is unused and TMN (only)
is used for alarm monitoring and controls. For specific TMN
Initial Turnup requirements, refer to CD.
Select ports on I/O INTFC
module that will be used
to insert and drop service
channel data.
RF/Rptr PPP Transport
None
RF
Rptr
RF/Rptr
MCS-11 data
RF/Rptr
None
RF
Rptr
RF/Rptr
MCS-11 and
IP data
MDR-1056
04/03/07
4-39