Alcatel-Lucent MDR-8000 User Manual page 46

DTMF ALLOWS YOU TO DIALUP AND RING OTHER SITES USING THE 2-WIRE
HANDSET. ONLY THE RINGING IS DETECTED. COMMUNICATION OVER THE
HANDSET IS PARTY-LINE. DTMF ADDRESSING IS A LOCAL FUNCTION NOT A
NETWORK FUNCTION, THEREFORE, IF ONE OR MORE RADIOS ARE ASSIGNED
THE SAME DTMF ADDRESS, THEY WILL ALL RING WHEN THAT ADDRESS IS
Alcatel User Interface – [System, DS3, and DS1 Provisioning -- MDR-8000 DS3]
DIALED.
File View Setup Options
TO BE ABLE TO USE THE DTMF FUNCTION:
1. AUDIO 1 MUST BE SELECTED FOR 2-WIRE HANDSET OPERATION.
F3 F4
2. DTMF MUST BE TURNED ON (CHECKED) ON THE AUDIO PROVISIONING
SCREEN.
Prov. Save Alarm Status
3. 2-WIRE HANDSET MUST BE CONNECTED TO TEL JACK ON CONTROLLER
MODULE.
4. RADIOS MUST BE PROVISIONED WITH DTMF ADDRESS.
ELMC Address:
ELMC Description:
WHEN All Call Detect IS SELECTED, ALL TELEPHONES
RING WHEN CALL IS INITIATED. WHEN All Call Detect IS
Radio Configuration
NOT SELECTED, TELEPHONE ASSOCIATED WITH RADIO
WILL NOT RING. USEFUL IN SITUATIONS WHERE MULTIPLE
RADIOS ARE CONNECTED AT ONE SITE.
AUDIO 1: Channel
Level
AUDIO 2: Channel
Level
Channel 1
RS-232
Channel
TMN
MCS RSS
RDS/RAS/RCD
Thursday, March 7, 2000
4-36
F5 F6
Analog Monitor Performance
LOCAL DS3 PROVISIONING
J7914
DURANGO
Communicating***
Service Channel
Off E-Lead
0/0 M-Lead
Off E-Lead
0/0 M-Lead
Channel 2
3 MCS Transport
Address
J310 Modem
1:27:15 PM USI Version R1.03
Figure 4 - 20 Audio 1 Provisioning (Sheet 2 of 2)
F7 F8
Station Alarm User Control
DS3 Facilities
-GND All Call Detect
Norm 2-Wire Auto Squelch
-GND
DOUBLE CLICK TO ENABLE
(000 DISPLAYS). ENTER 3-DIGIT
Norm
STATION CALL NUMBER. OPERATOR
CAN DIAL THIS NUMBER AND RING/
Repeater D/1
COMMUNICATE WITH THE STATION
VIA ORDERWIRE. SELECT OFF TO
RF/Rptr PPP Transport
DISABLE DTMF.
A12A J308/J309 Input Clocks
J308/J309 Termination
Controller Version R1.03 MDR-8000 3-DS3
F9
Provisioning
WaySide DS1 Facilities
DTMF
Address 00
MDR-1035B
RF/Rptr
09/16/04