Alcatel-Lucent MDR-8000 User Manual page 116

i
Save the calibrated values. Click next
Abort Back
Disconnect power meter and sensor
l
from connector.
RF OUT
Reconnect cable to
m
connector.
Figure 5 - 21 XMTR Output Level Calibration (Sheet 3 of 5)
5-58
Note
Ensure ATPC is disabled.
Next
Click Next.
Successfully stored calibration data
Back
Observe RF MON label on XMTR
n
front panel. On label, is the measured
READ level in dBm or Vdc?
RF OUT
Storing calibration data, please wait...
Abort Back
k
Finish
Click Finish.
Calibration is
complete.
If labeled READ X.X dBm, go to step o.
If labeled READ X.X Vdc, go to step s.
j
Next
Click Next.
MDR-6061
09/08/05