Table of Contents
Advertisement
Adjusting the LCD Monitor
Factory Presets, Auto Adjust, and User Settings
Factory Presets: To enable DTF-510U to display the image with the best quality based on the incoming signal,
the unit is programmed with some standard display modes set as defaults.
Auto Adjust: When DTF-510U receives a signal that is other than a default display mode, and if the horizontal
DTF-510
frequency is between 28 to 64 kHz and the vertical frequency is between 48 to 75 Hz, an Auto Adjust function
will automatically set the horizontal and vertical position, phase, and pitch.
User Settings: When you manually set the display using the On Screen Display (OSD) function, the settings are
stored within DTF-510U for use the next time the unit receives a similar signal. This is applicable to all display
DTF-510
modes.
Working with OSD (On Screen Display) Menu
To open the main MENU , press the MENU ( ) button.
Use the + ( ) or – ( ) buttons to select an option. When the option you want to adjust is highlighted, press
the ENTER ( ) button. The current settings and adjustment sub-menu for that option will appear.
Use the + ( ) or – ( ) buttons to adjust the option settings.
When you have made your changes, press the ENTER ( ) button to save. To exit, press the MENU ( ) button.
All settings are automatically saved when the OSD menu closes.
Contrast
Select to increase or
decrease image contrast.
Brightness
Select to increase or
decrease image brightness.
16
DTE-510UEN.ind
DTF-510
16
Phase
Select to reduce or
eliminate horizontal
distortion lines. ☞ P18
To automatically adjust,
use the RESET option.
Pitch
Celect to reduce or elim-
inate vertical distortion
lines. ☞ P18
To automatically adjust, use
the RESET option.
03.4.9, 6:33 PM
Advertisement
Table of Contents
