Transponder Mode Selection - Garmin G950 Pilot's Manual

0

TRANSPONDER MODE SELECTION

Mode selection can be automatic (Ground and Altitude Modes) or manual (Standby, ON, and Altitude Modes).
The STBY, ON , and ALT Softkeys can be accessed by selecting the XPDR Softkey.
Selecting a transponder mode:
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the desired softkey to activate the transponder mode.
GROUND MODE
Ground Mode is normally selected automatically when the aircraft is on the ground. The transponder
powers up in the last mode it was in when shut down. Ground Mode can be overridden by selecting any one
of the Mode Selection Softkeys. A green GND indication and transponder code appear in the mode field of
the Transponder Data Box. In Ground Mode, the transponder does not allow Mode A and Mode C replies,
but it does permit acquisition squitter and replies to discretely addressed Mode S interrogations.
When Standby Mode has been selected on the ground, the transponder can be returned to Ground Mode
by selecting the GND Softkey.
190-01146-00 Rev. A
STBY ON ALT
1 2 3 4
Figure 4-29 Transponder Softkeys (PFD)
Figure 4-30 Ground Mode
Garmin G950 Pilot's Guide for the Tecnam P2006T
XPDR
IDENT
VFR CODE IDENT
GND
Selecting the BACK Softkey
returns to the top-level softkeys.
IDENT
5 6 7
Selecting the BACK Softkey returns to the mode selection softkeys.
GND
Mode
AUDIO PANEL AND CNS
BACK ALERTS
BKSP BACK ALERTS
103