G950 System Message Advisories - Garmin G950 Pilot's Manual

G950 SYSTEM MESSAGE ADVISORIES

This section describes various G950 system message advisories. Certain messages are issued due to an LRU
or an LRU function failure. Such messages are normally accompanied by a corresponding red 'X' annunciation
as shown previously in the G950 System Annunciation section.
This Section provides information regarding G950 message advisories that may be displayed by the
NOTE:
system. Knowledge of the aircraft, systems, flight conditions, and other existing operational priorities must
be considered when responding to a message. Always use sound pilot judgment. The Pilot's Operating
Handbook (POH) takes precedence over any conflicting guidance found in this section.
MFD & PFD MESSAGE ADVISORIES
Message
DATA LOST – Pilot stored data was
lost. Recheck settings.
XTALK ERROR – A flight display
crosstalk error has occurred.
PFD1 SERVICE – PFD1 needs service.
Return unit for repair.
MFD1 SERVICE – MFD1 needs
service. Return unit for repair.
MANIFEST – PFD1 software
mismatch. Communication halted.
MANIFEST – MFD1 software
mismatch. Communication halted.
PFD1 CONFIG – PFD1 configuration
error. Config service req'd.
MFD1 CONFIG – MFD1 configuration
error. Config service req'd.
SW MISMATCH – GDU software
version mismatch. Xtalk is off.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
MFD1 COOLING – MFD1 has poor
cooling. Reducing power usage.
PFD1 KEYSTK – PFD1 [keyname] Key
is stuck.
MFD1 KEYSTK – MFD [keyname] Key
is stuck.
CNFG MODULE – PFD1 configuration
module is inoperative.
PFD1 VOLTAGE – PFD1 has low
voltage. Reducing power usage.
MFD1 VOLTAGE – MFD1 has low
voltage. Reducing power usage.
190-01146-00 Rev. A
Comments
The pilot profile data was lost. System reverts to default pilot profile and settings. The
pilot may reconfigure the MFD & PFD with preferred settings, if desired.
The MFD and PFD are not communicating with each other. The G950 system should
be serviced.
The PFD and/or MFD self-test has detected a problem. The G950 system should be
serviced.
The PFD and/or MFD has incorrect software installed. The G950 system should be
serviced.
The PFD configuration settings do not match backup configuration memory. The G950
system should be serviced.
The MFD configuration settings do not match backup configuration memory. The
G950 system should be serviced.
The MFD and PFD have different software versions installed. The G950 system should
be serviced.
The PFD and/or MFD is overheating and is reducing power consumption by dimming
the display. If problem persists, the G950 system should be serviced.
A key is stuck on the PFD and/or MFD bezel. Attempt to free the stuck key by pressing
it several times. The G950 system should be serviced if the problem persists.
The PFD1 configuration module backup memory has failed. The G950 system should
be serviced.
The PFD1 voltage is low. The G950 system should be serviced.
The MFD voltage is low. The G950 system should be serviced.
Garmin G950 Pilot's Guide for the Tecnam P2006T
APPENDIX A
299