Grizzly G1035 Owner's Manual page 13

Voltage Conversion
The voltage conversion MUST be performed by
an electrician or a qualified service personnel.
The voltage conversion procedure consists of
rewiring the motor and installing the correct plug.
A wiring diagram is provided on Page 49 for your
reference.
IMPORTANT: If the diagram included on the
motor conflicts with the one on Page 49, the motor
may have changed since the manual was printed.
Use the diagram included on the motor junction
box cover instead.
Items Needed
• Phillips Head Screwdriver #2 ..................... 1
• Electrical Tape ............................ As Needed
• Wire Nut (14 AWG x 1) ............................... 1
• Plug 6-15 .................................................... 1
To convert the Model G1035/G1035P to 240V:
1.
DISCONNECT SHAPER FROM POWER!
2. Cut off the included plug.
3. Open the motor junction box, then loosen
the terminal screws indicated in Figure 5.
Remove the wires connected to those termi-
nals.
120V Single-Phase
Motor (Pre-Wired)
Loosen
These
Terminal
Screws
Figure 5. Locations to loosen terminal screws.
Model G1035/G1035P (Mfg. Since 4/10)
Qty
Gnd
6 5
4. Connect the motor wires, as shown in Figure
6.
5.
Connect the white wire from the #6 terminal
on the switch with a wire nut. Once snug,
wrap electrical tape around the wire nut and
the connected wire, to reduce the likelihood
of the wire nut vibrating loose during motor
operation.
240V Motor
Wire Nut
on White
Wire
5
Tighten
These
Terminal
Screws
Figure 6. Motor rewired for 240V.
6. Close and secure the motor junction box.
7. Install a 6-15 plug on the end of the cord,
according to the instructions and wiring dia-
grams provided by the plug manufacturer.
—If the plug manufacturer did not include
instructions, the wiring of a generic NEMA
6-15 plug is illustrated in the Wiring sec-
tion on Page 49.
Gnd
6
-11-