Pioneer PRO-141FD Service Manual page 78

1
A
Reference 1
Combinations of inputs for 2-screen display
The combinations of inputs for 2-screen display are shown in the table below:
INPUT1
INPUT2
INPUT3
Main
INPUT4
B
Screen
INPUT5
INPUT6
INPUT7
INPUT8
As there is only one digital receiver, a combination of two digital signals is not possible.
As signals input to the 3RCA and DSUB connectors are both output via the same RGB SW output, they cannot be selected in combination.
If signals that are not allowed to be selected in combination are selected, the signal for the subscreen will become that of the INPUT
connector, with the number increased by 1 from the specified number.
Combinations of inputs for BANNER PIP display
C
The combinations of inputs when the BANNER PIP function is enabled for the Integrator menu are shown in the table below:
INPUT1
INPUT2
INPUT3
Main
INPUT4
Screen
INPUT5
INPUT6
INPUT7
INPUT8
D
Some inputs cannot be combined for the BANNER PIP function for the same reasons as with the 2-screen display function.
Note: The inputs for which the BANNER PIP function is available are only PC signals (XGA@60 and WXGA@60) to
INPUT connectors 3–8.
As a PC input is not provided for INPUT connectors 1 and 2, the BANNER PIP function is not available for those inputs.
With the combinations of inputs with ×'s in the above table, only the main screen is displayed, and a Banner screen is not displayed.
While the BANNER PIP function is activated, the 2-screen display function cannot be activated.
Reference 2
E
Limitations During Operation of Each Function, and Notes
During operation of input priority:
Input priority does not function during Standby nor Power Management mode.
Input priority does not function during 2-screen mode.
For 4 seconds after the unit is turned on, input priority does not function (while inputs are being detected after
the unit is turned on).
During operation of BANNER PIP:
The unit does not enter 2-screen mode.
During setting on the menu, BANNER PIP is canceled, except in some cases.
On the Integrator menu
F
Upon activation of the Integrator menu, the values for the PICTURE items on the Home menu will be reset to
the initial values (as the Picture Preset function is activated).
Before activating Monotone or Studio mode, reset the Picture Preset values.
78
1
2
BANNER PIP screen
INPUT1 INPUT2 INPUT3 INPUT4
(VIDEO) (3RCA) (DSUB) (DVI)
: Connectors provided only for ELITE models
: Connectors common to both ELITE and regular models
Subscreen
INPUT1 INPUT2 INPUT3 INPUT4
(VIDEO) (3RCA) (DSUB) (DVI)
: Connectors provided only for ELITE models
: Connectors common to both ELITE and regular models
PRO-141FD
2
3
INPUT5 INPUT6 INPUT7 INPUT8
(HDMI1) (HDMI2) (HDMI3) (HDMI4)
INPUT5 INPUT6 INPUT7 INPUT8
(HDMI1) (HDMI2) (HDMI3) (HDMI4)
3
4
4