Each Setting And Adjustment - Pioneer PRO-141FD Service Manual

5

8. EACH SETTING AND ADJUSTMENT

1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.
8.1 ADJUSTMENT REQUIRED WHEN THE UNIT IS REPAIRED OR REPLACED
When any of the following assemblies is replaced
POWER SUPPLY Unit
DIGITAL Assy
X DRIVE Assy
Y DRIVE Assy
Service Panel Assy
MAIN Assy (Note)
I/O Assy
SENSOR Assy
Other assemblies
Note: After the MAIN Assy is replaced, be sure to perform FINAL SETUP, according to the size and
destination of the PDP. When performing FINAL SETUP using RS-232C commands, send the FAY
command first then send necessary commands. When performing FINAL SETUP using the Factory
menu, perform settings for OPTION on the Service Factory screen.
<Elite models>
60-inch, for North America: ELITE60 (FSTS82)
<Pioneer models>
60-inch, for Europe: PIO60 (FSTS92)
60-inch, for North America: PIO60_A (FSTS94)
60-inch, for Japan: PIO60_J (FSTS96)
5
6
Refer to "8.3 HOW TO CLEAR HISTORY DATA" .
Writing of backup data is required.
Refer to the "8.2 BACKUP OF THE EEPROM
(DIGITAL ASSY)".
No adjustment required
No adjustment required
Refer to "8.3 HOW TO CLEAR HISTORY DATA" and
"8.4 ADJUSTMENTS WHEN THE SERVICE PANEL
ASSY IS REPLACED".
Execute section [4-5] AUTO ADJUSTMENT of
6.2 [4] INITIALIZE.
No adjustment required
No adjustment required
Backup data are automatically copied during the next
power-off.
No adjustment required
PRO-141FD
6
7
7
8
A
B
C
D
E
F
187
8