Y1152A Switch Control - Agilent Technologies 34945A User Manual

Y1152A Switch Control

The switch control for the Y1152A distribution board is shown below. All
channels are driven in the PAIRed mode (Preset state). See Figure 4-12 for
additional information. See Chapter 2 for bank-specific channel numbering.
* Note that for switches connected to SW1, path closed is accomplished with
the ROUTe:OPEN command and path opened is accomplished through the
ROUTE:CLOSe command.
Agilent 34945A Microwave Switch/Attenuator Driver Module User's Guide
Channel / Switch 2
Channel 1xx1 / SW2 Path 1
Channel 1xx2 /SW2 Path 2
Channel 1xx3 /SW2 Path 3
Channel 1xx4 /SW2 Path 4
Channel 1xx5 /SW2 Path 5
Channel 1xx6 /SW2 Path 6
Channel 1xx7 /SW2 Open All 1
Channel 1xx8 /SW2 Open All 2
Channel / Switch
Channel 1xx1 /SW1 Path1
Channel 1xx2 /SW1 Path2
Channel 1xx3 /SW1 Path3
Channel 1xx4 /SW1 Path4
Channel 1xx5 /SW1 Path5
Channel 1xx6 /SW1 Path6
Channel / Switch
Channel 1xx7 /SW2
Channel 1xx8 /SW3
Additional Operating Information
Path Closed
ROUT:CLOS (@1xx1) Close another path or open all
ROUT:CLOS (@1xx2) Close another path or open all
ROUT:CLOS (@1xx3) Close another path or open all
ROUT:CLOS (@1xx4) Close another path or open all
ROUT:CLOS (@1xx5) Close another path or open all
ROUT:CLOS (@1xx6) Close another path or open all
ROUT:CLOS (@1xx7) note: use either channel
ROUT:CLOS (@1xx8)
Path State
Path Closed*
ROUT:OPEN (@1xx1)
ROUT:OPEN (@1xx2)
ROUT:OPEN (@1xx3)
ROUT:OPEN (@1xx4)
ROUT:OPEN (@1xx5)
ROUT:OPEN (@1xx6)
Switch State
State A
ROUT:OPEN (@1xx7)
ROUT:OPEN (@1xx8)
Path Open
to open all
Path Opened*
ROUT:CLOS (@1xx1)
ROUT:CLOS (@1xx2)
ROUT:CLOS (@1xx3)
ROUT:CLOS (@1xx4)
ROUT:CLOS (@1xx5)
ROUT:CLOS (@1xx6)
State B
ROUT:CLOS (@1xx7)
ROUT:CLOS (@1xx8)
5
95