Restoring 34945A Factory Settings - Agilent Technologies 34945A User Manual

4
Introduction to Programming
All other switch/attenuator settings in place prior to the power cycle or reset
event remain unchanged. These events, however, do cause the 34945EXT to
recognize new topologies (external switches, power configurations).
N O TE
The Web Interface 'Reset All Remotes' Button
The '
(Web interface) programming diagram resets all distribution board settings on
all attached 34945EXT modules to their user-specified default states, preset
settings, and individually-set switch or attenuator settings. This button is
equivalent to the SCPI command:
<slot>

Restoring 34945A Factory Settings

Factory settings for the 34945A, all attached 34945EXT modules, and all
installed distribution boards are restored with the command:
<slot>
command and its subsequent settings override any previously stored preset,
default, and power-on or reset settings. The factory settings grouped according
to 34945EXT, bank, and channel are shown in Table 4-1.
86
If a channel is configured for a single drive in pulsed mode,
operations are undefined. When these channels are configured to a
default state of
Reset All Remotes ' button located to the right of the switch or attenuator
SYSTem:CPON <slot>
is the 34980A slot where the selected 34945A is installed.
SYSTem:RMODule:RESet <slot>
is the 34980A slot where the selected 34945A is installed. This
Agilent 34945A Microwave Switch/Attenuator Driver Module User's Guide
, no action is taken on these channels.
OPEN
OPEN