Calling Tool Management - HEIDENHAIN TNC 640 User Manual

Tools | Tool management (option number 93)

Calling tool management

Refer to your machine manual.
The procedure for calling the tool management may
differ from that described below.
Select the tool table: Press the TOOL TABLE soft
key
Scroll through the soft-key row
Press the TOOL MANAGEMENT soft key
The control switches to the new table view.
Tool management view
In the new view, the control presents all tool information in the
following four tabs:
Tools: Tool specific information
pockets: Pocket-specific information
Tooling list: List of all tools in the NC program that is selected in
the Program Run mode (only if you have already created a tool
usage file)
Further information:
T usage order: List of the sequence of all tools that are inserted
in the program selected in the Program Run mode (only if you
have already created a tool usage file)
Further information:
If a pallet table is selected in the Program Run operating
mode, the Tooling list and T usage order are calculated
for the entire pallet table.
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
"Tool usage test", page 263
"Tool usage test", page 263
6
271