HEIDENHAIN TNC 640 User Manual page 418

10
Group Gruppen-
name nummerID
TT tool touch probe for tool measurement
350
Preset from touch probe cycle (probing results)
360
418
Systemdaten- Index
nummer
70 1
2
71 1/2/3
72 -
75 1
2
3
76 1
2
3
4
77 -
78 -
79 -
80 -
1 Coordinate
2 Axis
3 Coordinate
4 Coordinate
5 Axis
6 Coordinate /
axis
10 -
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Programming Q Parameters | Additional functions
Description
TT: Touch probe type
TT: Line in the tool touch probe table
TT: Touch probe center (REF system)
TT: Touch probe radius
TT: Rapid traverse
TT: Measuring feed rate with stationary
spindle
TT: Measuring feed rate with rotating spindle
TT: Maximum probing path
TT: Safety clearance for linear measurement
TT: Safety clearance for radius measurement
TT: Distance from the lower edge of the
cutter to the upper edge of the stylus
TT: Spindle speed
TT: Probing direction
TT: Activate radio transmission
TT: Stop probing movement upon stylus
deflection
Last preset of a manual touch probe cycle,
or last touch point from Cycle 0 (input coordi-
nate system).
Compensations: length, radius, and center
offset
Last preset of a manual touch probe cycle, or
last touch point from Cycle 0 (machine coordi-
nate system, only axes from the active 3-D
kinematics are allowed as index).
Compensation: only center offset
Result of measurement in the input system
of touch probe Cycles 0 and 1. The measure-
ment result is read out in the form of coordi-
nates. Compensation: only center offset
Last preset of a manual touch probe cycle,
or last touch point from Cycle 0 (workpiece
coordinate system) The measurement result
is read in the form of coordinates.
Compensation: only center offset
Axis values, not compensated
Readout of the measurement results in the
form of coordinates / axis values in the input
system from probing operations.
Compensation: only length
Oriented spindle stop