Summertime/Wintertime Conversion - Siemens LOGO! Manual

3.7.14

Summertime/wintertime conversion

You can enable or disable automatic summertime/wintertime conversion
● in parameter assignment mode by calling the "Set.." menu command
● in programming mode by calling the "Setup" menu command.
To enable/disable automatic S/W Time conversion in programming mode:
1. Switch LOGO! to programming mode.
2. You are now in the main menu and want to select the 'Setup' menu command: Press
or
3. Confirm 'Setup': Press OK
4. Move the '>' cursor to 'Clock': Press
5. Confirm 'Clock': Press OK
6. Move the '>' cursor to 'S/W Time': Press
7. Confirm 'S/W Time': Press OK
LOGO! shows the following display:
The current setting of automatic S/W Time conversion is shown on the bottom row. The
default setting is 'Off': disabled.
To enable/disable automatic S/W Time conversion in parameter assignment mode:
If you want to enable/disable automatic S/W Time conversion in parameter assignment
mode, select in the parameter assignment menu 'Set..', then menus 'Clock' and 'S/W Time'.
You can now enable/disable automatic S/W Time conversion.
Enabling summertime/wintertime conversion
You now want to enable this conversion and define or set its parameters:
1. Move the '>' cursor to 'On': Press
2. Confirm 'On': Press OK
The display shows:
3. Select the desired conversion: Press
LOGO!
Manual, 10/2017, A5E01248535-AA
3.7 Writing and starting the circuit program
or
or
or
or
Programming LOGO!
93