Table Of Contents - Siemens LOGO! Manual

Table of contents

Preface ................................................................................................................................................... 3
1 Getting started with LOGO! ................................................................................................................... 11
2 LOGO! installation and wiring ................................................................................................................ 25
2.1 Modular LOGO! setup ............................................................................................................. 27
2.1.1 Maximum setup ....................................................................................................................... 27
2.1.2 Setup with different voltage classes ....................................................................................... 29
2.1.3 Compatibility ........................................................................................................................... 31
2.2 Installing/removing LOGO! ..................................................................................................... 31
2.2.1 DIN rail mounting .................................................................................................................... 32
2.2.2 Wall-mounting ......................................................................................................................... 34
2.2.3 Mounting the LOGO! TD ......................................................................................................... 35
2.2.4 Labeling LOGO! ...................................................................................................................... 36
2.3 Wiring LOGO! ......................................................................................................................... 36
2.3.1 Connecting the power supply ................................................................................................. 37
2.3.2 Connecting the LOGO! TD power supply ............................................................................... 38
2.3.3 Connecting LOGO! inputs ....................................................................................................... 39
2.3.4 Connecting outputs ................................................................................................................. 46
2.3.5 Connecting the EIB bus .......................................................................................................... 48
2.3.6 Connecting the AS interface bus ............................................................................................ 49
2.3.7 Connecting modems ............................................................................................................... 51
2.4 Putting into operation .............................................................................................................. 52
2.4.1 Switching the LOGO!/Power On ............................................................................................. 52
2.4.2 Putting a CM EIB/KNX into operation ..................................................................................... 54
2.4.3 Operating states ...................................................................................................................... 55
3 Programming LOGO! ............................................................................................................................ 57
3.1 Connectors .............................................................................................................................. 58
3.2 EIB inputs/outputs ................................................................................................................... 60
3.3 Blocks and block numbers ...................................................................................................... 61
3.4 From circuit diagram to LOGO! program ................................................................................ 63
3.5 The four golden rules for operating LOGO! ............................................................................ 66
3.6 Overview of LOGO! menus ..................................................................................................... 68
3.7 Writing and starting the circuit program .................................................................................. 69
3.7.1 Selecting programming mode ................................................................................................. 69
3.7.2 The first circuit program .......................................................................................................... 70
3.7.3 Circuit program input ............................................................................................................... 71
3.7.4 Assigning a circuit program name .......................................................................................... 75
3.7.5 Password ................................................................................................................................ 76
3.7.6 Switching LOGO! to RUN mode ............................................................................................. 81
3.7.7 Second circuit program ........................................................................................................... 83
LOGO!
Manual, 10/2017, A5E01248535-AA
7