Modifying Parameters - Siemens LOGO! Manual

5.1.3

Modifying parameters

You first select the parameter you want to edit (Page 218).
You change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change:
Press
2. To change this value: Press
3. To apply the value: OK
Note
When changing the time parameter when the system is in RUN, you can also change the
timebase (s=seconds, m=minutes, h=hours). This does not apply if the time parameter
represents the result of another function (for an example, see the "On-delay (Page 123)"
topic). In this case you can neither change the value nor the timebase. The current time is
reset to zero when you change the timebase.
Current value of a time T
View of a time T in parameter assignment mode:
You can change the configured time T.
Current timer value
View of a timer cam in parameter assignment mode:
You can change the on/off times and the day.
LOGO!
Manual, 10/2017, A5E01248535-AA
or
or
5.1 Selecting parameter assignment mode
Configuring LOGO!
219