Setting The Start Screen - Siemens LOGO! Manual

Configuring LOGO!
5.2 Setting the default values for LOGO!
To set the number of AIs in programming mode:
If you want to set the number of AIs in programming mode, select 'Setup' in the main menu,
then menu 'BM AI NUM'. You can now set the number of AIs as described earlier (as of step
6.).
Note
If you change the number of analog inputs, LOGO! restarts automatically.
5.2.5

Setting the start screen

You can select the default setting for the start screen that LOGO! and the LOGO! TD will
display in RUN mode. You make this selection from the parameter assignment mode by
means of the set menu ("StartScreen" menu item).
To select the start screen:
1. Select parameter assignment mode (Page 215).
2. On the parameter assignment menu,
select 'Set..': Press
3. Confirm 'Set..': Press OK
4. Move to 'StartScreen': Press
Confirm 'StartScreen': Press OKLOGO! shows the following display:
The current setting of the start screen is shown in the bottom row. The default setting is
'Clock'.
You can choose between the display of the current time-of-day and date, or the values of
the digital inputs:
5. Select the desired default setting: Press
6. To confirm your entry: Press OK
LOGO! displays your selection.
Power the LOGO! Basic off then on to make your changes take effect. When LOGO! is in
RUN mode, both LOGO! and the LOGO! TD will display the start screen that you selected.
226
or
or
or
Manual, 10/2017, A5E01248535-AA
LOGO!