Configuring Logo; Selecting Parameter Assignment Mode - Siemens LOGO! Manual

Configuring LOGO!

Parameter assignment refers to the configuration of the block parameters. You can set delay
times for time functions, the switching times of timers, counter threshold values, the
monitoring interval of an hours counter, the on and off thresholds of the trigger, and more.
You can configure the parameters
● In programming mode
● In parameter assignment mode
In programming mode, the author of the circuit program also sets the parameters
Parameter assignment mode allows the editing of parameters without having to modify the
circuit program. This feature is available so that you can edit parameters without having to
change to programming mode. The advantage: The circuit program remains protected, but
can be adapted by the user to meet specific requirements.
Note
In parameter assignment mode, LOGO! continues execution of the circuit program.
5.1

Selecting parameter assignment mode

Press ESC to change from RUN to parameter assignment mode:
Note
The following applies to earlier device versions up to 0BA2: you open parameter assignment
mode by pressing ESC+OK.
LOGO!
Manual, 10/2017, A5E01248535-AA
5
215